What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 22.06.2025 00:08
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
The bolt then partially travels down the line to your home.
For this case there are devices called Metal oxide varistors (MOV).
There are two important concepts here.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
Nintendo Switch 2 launch: GameStop investigating claims of console damage - NBC News
These devices are installed between the “hot” and “neutral” and protective ground.
In schematic diagrams this is the symbol for a fuse:
This is 'the assistant's answer'
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
It also is a device that limits the change in current flow.
Who’s the smartest Hollywood celebrity?
There are three different concepts here that are getting confused.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
Do women like men who have slept with many women?
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
[old diagram got deleted by accident]
but I think this circuit , shows a few more pieces.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
An AC voltage/ current source, and an ac inductive load.
I post the exact comment here.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
He then describes Rainy Season and Lightning.
Barnstars:
Taylor Swift Spotted at Nashville Wedding In Gorgeous Blue & Pink Dress - Just Jared
The MOV will conduct when the voltage exceeds 50% of line voltage.
At least they know the answer if they wanted it.
This is where the MOV conducts again, and dissipated the energy.
This one hit behind the barn.
But it can get overloaded, and no longer works.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
The third is lightning and “how it gets conducted into a home.”
but this device (an Inductor) … impedes the rapid changes in the current.
One
Can the fuse protect the electronic devices from lightning instead of a surge protector.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
the problem then depends on "how fast does the fuse operate?".
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
Dolorem suscipit perferendis ea aut quo et ea.
what exactly is a ‘surge’ protector?
First Sentence:
so, what happens?
Totam aut neque cum voluptas velit eum tempore.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
What does a fuse do?
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
The other is “what does a “fuse” do?”
These are simplified answers to the original question, and does not change anything I wrote above.
[image of Common-mode choke]
At one ohm, the resistor has a maximum of 1 watt power.
nine
So, the voltage could go up to 500 volts, and the fuse will not open up.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
He then describes the function of a fuse.
Here is a simplified AC power diagram.
What is lightning?
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
(Dc diagram shown, AC is similar).
He then asserts :
Now when you have a certain ac resistance, then a current flows in a loop.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
eight
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
A circuit breaker is similar, but is resettable.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
a photo is worth a thousand words.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
2024–10–16 [ OO OLAOYE OYEBODE ]
This device then solves the entire problem.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
Because the load is inductive, the current lags the voltage.(by a bit).
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
It seems Mohan does not understand the difference between a comment and an Answer.
This is where this question deviates from being a 'generic' question, and becomes more specific.
Upvotes:
2024–10–14 [Omar Gharbi Omar Gharbi ]
2024–10–10[John johnson John Johnson ]
But… the neutral is now “floating” because of the 1 ohm resistance.
A fuse is a non-resetable over current circuit protector.
Edit 2024–10.
One is “what exactly is in a ‘surge protector’ ? ”